For a long time the Daiwa CNA‐1001 did a fine job alongside my IC‐7300, helping my 10/20/40m end‐fed onto bands it was never designed for. But as I spent more time on the air, mostly in FT8 and other digital modes, I started to run into its limits. In January 2026 I replaced it with an LDG AT‐1000ProII, together with the matching M‑1000 external meter.
Why replace the Daiwa?
The first reason is range. The Daiwa covers 3.5 to 30 MHz and matches loads between roughly 10 and 300 ohms. That rules out 160m and 6m altogether, and an end‐fed used well away from its design bands can easily present an impedance outside that window. The LDG covers 1.8 to 54 MHz continuously and matches 6 to 1000 ohms (16 to 150 ohms on 6m), so it should get my antenna onto quite a few more bands.
The second reason is digital modes. FT8 keeps the transmitter keyed at full power for almost 13 seconds per transmission, which is much harder on a tuner than speech on SSB. The Daiwa only carries a PEP rating, which says little about a continuous carrier. That’s why I only ever used the Daiwa on digital modes with the output power of the transceiver turned down. LDG rates the AT‐1000ProII separately for digital modes: 600 W for FT8 and 500 W for other digital modes such as PSK and RTTY, against 1000 W on SSB and 750 W on CW. With the 100 W from my IC‐7300 that leaves a very comfortable margin, so turning the power down is no longer necessary.
Then there’s convenience. The Daiwa has no memory, so every change of band means a full tune. The LDG remembers the settings for each frequency, with more than 4,000 memories spread over its two antenna outputs, and recalls them in about 0.2 seconds. When you hop between bands chasing FT8 openings, that makes a real difference.
The M‑1000 meter
Alongside the tuner I bought the M‑1000, LDG’s external meter for the AT‐1000ProII. It’s a proper analogue meter that shows forward power, reflected power or SWR, on a 0–100 W or 0–1000 W scale, with a choice between average and peak power. Average suits constant‐carrier modes like FT8 and RTTY; peak is better for SSB.
A nice touch is that the meter works independently of the tuner’s own bargraphs. I can keep an eye on forward power and SWR on the tuner while the M‑1000 shows reflected power, so all three are visible at once. And let’s be honest: a needle meter on the desk simply looks good in the shack. 😉